Tefcold MTF Series, User Manual

Page: 10 / 40

10
EN
3 – INSTALLATION
3.1 – SELECTION OF LOCATION
OF THE EQUIPMENT
The operation environment is very
important in order for the equipment
to operate soundly. Make sure that the
conditions stated below are provided
in the selection of the location where
the equipment will be installed with
regards to the cooling performance and
energy consumption to remain within
the proper values.
• A bowless, flat and solid ground
must be chosen for the equipment.
• Make sure that the equipment is
vertically fixed at the wall.
• The size of the room where the
equipment will be used must be 1 m
3
for each 8g of refrigerant. The amount
of refrigerant that your equipment
contains is written on the label on the
upper left part in the inner rear cabin
(Image G G ).
• There must be a grounded and solid
plug close to the equipment.
• The refrigerant gasses used in your
equipment are pressured gasses and
may cause hazard of explosion when
heated. For preventing such hazards,
locate the equipment at least 1 m away
from heat sources (oven, stove, furnace,
radiator, etc.).
• The equipment must be placed
at a location where there is no direct
sunlight.
• The equipment must be placed
away from locations that have air
stream (across the air conditioner
air openings, under ventilators, at
doorsteps or windows etc.).
RECOMMENDATION
You must comply with the
authorized service's guidance
and recommendations for the
selection of location in order to
get the best performance from
the equipment.
3.2 – UNPACKING
Do the unpacking in accordance
with the unpacking instructions on the
equipment.
RECOMMENDATION
Wait for the Authorized
Service for the unpacking and
installation in the most proper
way.
The packaging materials are
suitable for recycling and may be
reused. Therefore, you should dispose
of the packing materials in accordance
with the waste instructions.
WARNING
The packaging materials
may be dangerous for
children. Please preserve
the packaging materials in a
place where children cannot
reach.