Owner’s manual
9
EN
ASSEMBLING FEET
OPERATION
cautious manner, and all the safety precautions are understood and followed. Children
should not play with this device. Children should not perform cleaning and servicing of
the device unsupervised.
• Pay attention! The surface of this device will get hot. To avoid burns and personal injury,
do not let bare skin touch hot surfaces. Use handles when moving the product. Closely
supervise any children and pets when in use.
• Do not route power cord underneath the heater or in front of air ventilation grilles.
• Do not insert anything into the ventilation grill!
• ALWAYS disconnect the product form the mains supply when it is not in use.
• DO NOT use this device if the cord or the plug is damaged, or the appliance is broken.
• Do not attempt to repair this appliance yourself. Only authorized and qualified personnel
may repair this device. Never disassemble this device.
• This heater is filled with a precise quantity of special oil. In case of an oil leakage, contact
an authorized service point for repair. Do not repair this device yourself!
• Fixed power cable may only be replaced in an authorized service point.
• Appliance for indoor and household use only.
• Clean this device in accordance to instructions listed in “Cleaning and Maintenance”
section. Keep the heater clean. Do not allow any objects to enter any ventilation or
exhaust opening as this may cause electric shock, fire or damage to the heater.
Before use, mount the attached feet to the body of the heater.
Fit the feet to the radiator by pushing it firmly onto the bottom
of the control panel (front) and the last fin (back) as shown in the
diagram. Place the heater on a flat, stable surface to check if it is
stable.
WARNING:
• Do not operate without feet attached.
• Operate the heater only in an upright position (feet on the bottom); any other position
could create hazardous situation.
1. Before using the heater, make sure it is placed on a flat and stable surface.
2. Insert the plug of the heater’s power cord into a suitable power mains socket.
3. Turn the thermostat knob fully in a clockwise direction to the maximum setting.
4. Turn on the power switch. When the heater is on, the power switch will illuminate.
5. Automatic temperature control:
When the desired room temperature has been
reached, the thermostat knob should be turned slowly anti-clockwise until the
thermostat is heard to click off and the light on the power switch is off. After this the
heater will keep the air temperature in the room at the set temperature by switching on
and off automatically.