Tecsun R-108, Operation Manual

Page: 13 / 27

www.tecsunradios.com.au
10
2. Press & hold the [BAND ] button until “
PRESET
” flashing and the
frequency counting; now the unit starts scanning and storing all
available SW band stations into the memories
；
3. When the frequency stops advancing, it means the ATS operation
is done completely. In the address state, you can rotate the
[TUNING] knob to browse for those stored stations.
● AIR ATS
1. Fully extend the telescopic antenna and press the [BAND] button
to select AIR band;
2. Press & hold the
[BAND
] button until “ PRESET ” flashing and the
frequency counting; now the unit starts scanning and storing all
available AIR band stations into the memories;
3. When the frequency stops counting, it means the ATS operation
is done completely. Now you can rotate the [TUNING] knob to
search for those stored stations.
Notes:
1. During ATS process in FM, MW / LW / SW or AIR, pre-stored radio
stations will be replaced automatically by the new found stations;
2. If there is too much interference in your surrounding or many
mirror/blank stations are being stored during ATS, you should
adjust the telescopic antenna (FM & SW) or rotate the radio for
better reception (MW & LW).
METHOD 2: STORING STATON MANUALLY
1. Select band and tune to your desired station
；
2. Press the [MEMORY] button with “
PRESET
” flashing;
3. Rotate the [TUNING] button to select the location you want
to store;
4. Press the [MEMORY] button again, and hear a sound of “Be—” ,
indicating that the station has been stored into memory.
Note: I f you do not press the [MEMORY] button again within
3 seconds, the radio will automatically exit the storage.