P. 16
Setup and Operation
V6.x // 06-2016
Info/Error-Messages at Network Communication
Error
N 1
No network communication. Problem with the internal network module.
The device automatically executes a
’reset’ for the internal network module
and retries communicating.
Try disconnecting the power supply, wait
… and reconnect.
Error
N 2
Error in the network communication. Signal destination cannot be reached / data
sending impossible.
Check the connections at the device and at the network router. Check parameter
setup at menu item
‘15.Network’...
Perform the function
’15.Network > Test > Ping: Yes’ …
Try to connect a different network device at this network cable, e.g. a Laptop.
If it does not work please contact your network administrator.
Error N2 only occurs in case of a domain like
‘oilview.de’ is entered for destination.
In case of entering an individual dest-IP, no Error N2 message will be shown.
Important:
The destination address must be a fixed IP address.
Otherwise the device retries sending again and again, caused by an
unreachable destination IP address.
Sending ...
’Sending’ is displayed if a data message is currently in process of sending.
The message destination can be setup as an IP address at menu item
‘15.Network => Dest. ...’
‘Sending...’ will be displayed periodically caused by an unreachable destination IP.
The destination should be a fixed IP address. IP + Port should be set correctly.
XML-Data:
Call the device via browser or program with command
IP-address / xml
Relay remote control:
Telecontrol / Teleswitching via relay of the
e-litro net
device:
The relay can be operated by remote commands from the browser at the
‘config’-page.
Please refer to the additional device parametrization.
Deactive = No switching
Active = State depends on level
On = Makes the relay operate (fix)
Off = Makes the relay release state (fix)
