TECOMEC S.r.l. Strada della Mirandola, 11 – 42124 Reggio Emilia (RE) – Italy
Tel. +39.0522.959001 – Fax +39.0522.959060 – [email protected] – www.geoline.com
11
10. Start Test: in order to check the operational status of the sensor, select Start Test with OK; in this
state the RED LED will flash every 100 msec, while the green one will flash at 1 sec intervals. The
display unit will be sent information on the readings taken and not the level value in the selected units of
measurement. The TEST icon and BIT unit of measurement are shown on the display unit.
11. Stop Test: press OK to return the system to standard display conditions.
Level 3 - Pump Configuration
•
Enable Pump: select Yes/No using the
↑
↓
buttons and confirm with OK, or
←
to cancel..
o
With Pump Enabled: select Manual or Automatic operation using
↑
↓
and confirm with OK, or
←
to cancel
With Automatic Operation:
•
Select Manual or Automatic Start using
↑
↓
and confirm with OK, or
←
to
cancel
•
Se Start Automatico: impostare il valore di Start della Pompa in % del livello
massimo della cisterna, al raggiungimento del quale la Pompa parte in
Automatico.
•
Automatic Stop: set the Stop value of the pump as a % of the maximum
tank level; when this level is reached, the Pump will stop Automatically.
