Basic manual for CP-1004 module
19
TXV 110 04
6. OPERATION
6.1 MODULE CONFIGURATION
The module is operated, set and diagnosed from the MOSAIC development environment.
6.2 PUTTING IN OPERATION
After connection and switching power supply on, the module is ready for its activity. On the
module panel there is MODE pushbutton for the displaying of the actually set Ethernet interface
IP address. Parameters of all interfaces are set from the Mosaic development environment. The
detailed set-up procedure is described in documentation TXV 004 10. Other activities (set-up,
programming, etc.) are carried out in the MOSAIC development environment.
7. DIAGNOSTICS
The basic diagnostic system of the module is part of the standard module software. The di-
agnostic system becomes active after module power supply is on, and works independently
from the user. The error states of the module and connected peripheral modules of the assem-
bly are signalised on the module panel and are available for processing by a superior system.
Detailed information can be found in documentation TXV 004 10.
8. REPLACEABLE SUBMODULES
The MR-01xx optional submodules of the serial interface are connected to the CP-1004 basic
module via the middle board into the position shown in fig 8.1.
If it is needed to plug-in or replace a submodule with a serial channel interface it is necessary
to loosen using a screwdriver the interlock on the bottom of the case. After removing the bottom
part of the case we can take out the set of boards from the rest of the case (push the boards
down by gentle press at the Ethernet connector and remove set of inside boards from the case).
After removing the top board with the indication LEDs and Ethernet interface connector the sub-
module is easily accessible. After submodule installation plug the boards in themselves – be
careful of pins bending and wrong insertion. Then insert the set of boards to the case carefully.
Be careful of bending LEDs and correct directions of a pushbutton and Ethernet connector. Af-
ter insertion to the case apply the bottom of the module.
Attention! The modules contain parts sensitive to electrostatic charges and thus rules for
safe handling of these circuits should be abided!
Handling is done only with modules which are not powered on!
During replacing the submodules it is necessary to check the correctness of
the connection of the submodule against the pins on the board. The module
connectors are not coded and thus if incorrectly connected and powered up
can damage the module or even the mainboard !!!
Summary of Contents for CP-1004
Page 2: ......
