4
Tecnotion
| www.tecnotion.com | [email protected]
Ironless linear mot
or manual - v
er
. 1.03
©2016 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior notice.
BEFORE YOU START
CH 1
1. [ BEFORE YOU START ]
Please read the following instructions very carefully.
They are important for a safe and warranted installation and operation of
the Linear Motor.
1.1. Important notice
Before installing and using the Linear Motor, read this instruction
manual carefully. The manufacturer declines all responsibility
in case of accident or damage due to negligence or lack of
observance of the instructions described in this manual. The
manufacturer also declines all responsibility in case of accident
or damage in conditions that differ from those indicated in the
manual; Tecnotion also declines all responsibility for damage
caused by improper use of the Linear Motor.
Handle the components of the Linear Motor with care, packed
as well as unpacked. Especially the magnet yokes are sensitive
to mechanical shocks. Never drop a magnet yoke or release it in
an uncontrolled way.
Do not expose the magnets to temperatures higher than 70° C.
The magnets may be demagnetized at higher temperatures.
Unpack the Linear Motor and check its integrity. If there is any
irregularity. If there is any irregularity contact the dealer or
manufacturer, signalling the nature of the defects.
Make a note of the serial number. This facilitates the
correspondence with the supplier.
Safety and information symbols:
The lightbulb describes a ‘Tip’.
The exclamation mark is a, non safety related, important notice
that the user should be aware of.
The warning signs inform about safety information that the user
should respect.
1.2 Safety warnings
The Linear Motor is used as a part of a machine. The machine
manufacturer or representative has to take care that the
machine as a whole fulfils all CE requirements.
The magnet yokes show large attraction forces on all soft
magnetic objects such as iron. These forces cannot be controlled
by hand. They may cause serious jamming danger. Do not
bring any soft magnetic objects (iron) nearer than 25 cm of the
magnetic side of the magnet yoke.
Magnetic sensitive objects like banking cards, pacemakers or
other magnetic information carriers may be damaged if they are
brought within 1m of the magnet yokes.
