tecnoelettra AT206, User Manual

Page: 10 / 24

Cod.Doc.2550041-REV 2.2.0 gb.doc
Pagina 10
3.2 - AT206 panel; LED indication decription
3.3 - AT206 panel; command buttons decription
If on, it indicates that one or
more alarms are active
If on, it
indicates that
the mains
voltage is ok
If on, it indicates that
the generator voltage
is ok
If on, indicates that
the mains contactor
is closed (the mains
supply the load)
If on, indicates that the generator
contactor is closed (the generator
supply the load)
If on, it indicates that
the voltage measured
is about the mains
If on, it indicates that
the voltage measured
is about the
generator
If on, it
indicates that
the automatic
test is enable
(Par. 3.4)
If on, it indicates that
the board is in
MANUAL (Par. 3.4)
If on, it indicates that
the board is in
AUTOMATIC
(Par. 3.4)
If on, it indicates
that the board is in
RESET (Par. 3.4)
It permit to activate
the automatic test
(Par. 3.4)
Board in MANUAL
function (Par. 3.4)
It permit to change the
type of measurement
showed by the display
It permit to close
the mains
contactor (active
only in MANUAL
function; press it
with MAN button in
the same time)
It permit to close
the generator
contactor (active
only in MANUAL
function; press it
with MAN button in
the same time)
It permit to start the generator
(enable only in MANUAL
function)
It permit to stop the generator (enable only
in MANUAL function)
Board in
AUTOMATIC function
(Par. 3.4)
Board in RESET
(Par. 3.4)
Type of
measurement
showed by the
display
If flashing, it indicate that the
engine is running and the
alarms are not enable. If on,
it indicate that the engine is
running and the alarms are
enable.
4 digit multifunction
display to show
measurement,
function and
alarms status