Electric Ovens rev. 15_____________________________________________________________________DIGITAL LINE
________________________________________________________________________________________ page. 7
WARNING
Ovens model EKF 423 D UD - EKF 423 D UD/0/015 –EKF 443 D UD - EKF 311 D UD - EKF 364 D
UD are not equipped with a drain pipe for cooking chamber drainage.
Connecting the power cable:
–
Mod. EKF 423 D UD
– EKF 423 D UD/0/015 – EKF 443 D UD – EKF 311 D UD
– EKF 364 D UD
–
EKF 464 D UD/001- EKF464DUD/0/037 – EKF 411 DUD/0/037 - EKF 464 DALUD/0/037
– To access
the terminal board, just remove the appliance's rear side-panel. Loosen the cable gripper and allow
the cable to pass through it. Arrange the conductors so that the earth conductor is the last to
detach from its terminal if the cable goes into a state of faulty traction. Connect the phase
conductor to the terminal marked “L1”, connecting the neutral conductor to the terminal marked
"N" and the earth conductor to the terminal marked with the symbol
. Tighten the cable
gripper and re-fit the rear side-panel of the appliance.
–
Modd. EKF 411D UD – EKF 464 D UD – EKF 411 D AL UD – EKF 416 D AL UD – EKF 464 D AL UD
-
To
access the terminal board, just remove the ppliance's rear side-panel. Loosen the cable gripper and
allow the cable to pass through it. Arrange the conductors so that the earth conductor is the last
to detach from its terminal if the cable goes into a state of faulty traction. Connect the phase
conductors to the terminals marked “L1” and “L2”, connecting the neutral conductor to the
terminal marked "N" and the earth conductor to the terminal marked with the symbol
according to the following lay-out:
(this electrical connection lay-out is located near the power supply terminal board). Tighten the
cable gripper and re-fit the rear side-panel of the appliance.
Any appliance must be connected to an equipotential system whose efficiency must first be
checked according to current legal regulations.
This connection must be made between different appliances by using the appropriate terminal
marked with the symbol
. The equipotential conductor must have a minimum diameter of
2,5mm
2
The equipotential terminal is at the rear of the appliance.
Safety thermal breaker - The appliance is supplied with a manually resetting thermal breaker to
protect against excessive, dangerous temperatures which could be accidentally generated inside. If
it is tripped, the device cuts off the power supply to the appliance.
5. Use instructions (for the user)
For first use, we advise you to let the appliance to run load-free for 30/40 minutes at a
temperature of 200°C. In this way, any unpleasant smells due to thermal insulation and residual
work grease are eliminated. This appliance must be used solely for the purpose for which it was
expressly designed, i.e. cooking foods in the oven. Any other use is considered unsuitable.
The appliance can be used: for all oven cooking of deserts, pizzas, meat, fish, vegetables, as well as
for re-conditioning cooled and frozen foods. When placing food in the cooking compartment,
leave a space of at least 40 mm between pans in order not to over-obstruct air circulation. Do not
use pans with higher than necessary edges: edges are barriers which prevent the circulation of hot
air (for cooking of bread and pastry; do not use pans with borders higher than 20mm, avoid that
products into the pan get in contact). Warm up the oven before every cooking operation (set a