Electric Ovens rev. 15_____________________________________________________________________DIGITAL LINE
________________________________________________________________________________________ page. 13
The cooking cycle ends when the temperature detected by the probe (introduced in the food)
reaches the value sets in the parameter "core temperature" (Regardless of the value of the
parameter "time")
Warning: Before removing the food from the oven after cooking with the core needle probe.
Carefully remove the hot probe from the cooked food, taking care not to leave it hanging
out of the cooking chamber as it could cause burns. We advise leaving it to cool down
before using it again – to avoid damaging pricks in the food.
To prevent any irreparable damage to the thermal piercing probe (core probe) do not use it
in high temperature cooking ABOVE 230°C, and ensure that the probe lead is not touching
any hot metal surfaces inside the oven.
21. Routine cleaning and maintenance
(WARNING: Cut power to the appliance before every operation)
General cleaning - Clean the oven when it is cold. Wash enamelled parts with lukewarm water and
soap, do not use abrasive products, steel wool, or acids, which could ruin them. To clean the steel
parts, do not use products containing chlorine (sodium hypochlorite, hydrochloric acid, etc) even if
diluted. Use specific off-the-shelf products or a little hot vinegar. Rinse thoroughly with water and
dry with a soft cloth. Clean the glass door of the oven with hot water only, and do not use rough
cloths. Do not allow foods (especially acid foods such as salt, vinegar, lemon, etc) to stagnate on
the stainless steel parts, because they could deteriorate. Do not wash the appliance with direct jets
of water, because if water enters, this could limit the appliance's safety. Do not use corrosive
substances (e.g. hydrochloric acid) to clean the oven' s support bench.
Cleaning the oven - It is good practice to clean the oven interior at the end of every day of duty. In
this way it will be easier to remove cooking residues, preventing them from burning when the
oven is next used. Clean it accurately with hot water and soap or with the appropriate off-the-shelf
products.
Cleaning the oven door –
(Except modd. EKF 411 D AL UD – EKF 416 D AL UD – EKF 464 D AL UD )
To clean the oven door thoroughly, proceed as follows:
-
fully open the door;
-
open the door;
-
insert the equipped plugs in the “A”
holes on the hinges (Fig. 5);
-
completely turn the movable hinge part “A”
(Fig. 7);
-
lift the door gently and withdraw it
(Fig. 6);
-
slowly close the door until the mechanical
“block”, lift it and remove it (Fig. 8).
-
put back the door in the initial position
by operating inverserly.
Fig. 5
Fig. 7
A