TECNOEKA Srl ______________________________________________________________ use and instruction manual
page. 14 ________________________________________________________________________________________
Fig. 6
Fig. 8
Replacing oven lamp - Electrically switch off the appliance; unscrew the protective glass cap with
the corresponding rings for airproofing; unscrew the lamp and replace it with another lamp
suitable for high temperatures (300°C), with the following characteristics:
-
Voltage
230/240 V
-
Power
15 W
-
Fitting
E 14
Refit the glass cap with the corresponding rings for airproofing and power up the appliance.
22. Possible faults
Type of fault
Cause
Corrective action
Control panel completely
off (the oven does not
work)
-
Incorrect electric connections to the mains
-
Check the mains connection
-
No mains voltage
-
Restore mains voltage
-
Thermal break safety device tripped
-
Reset the thermal break safety
device
-
Electronic card protection fuse (control
panel) burnt
-
Contact a qualified technician
Cooking cycle set and
push button
pressed: the oven does
not work
-
Door open or ajar
-
Close the door
-
Damaged door switch device
-
Contact a qualified technician to
repair the sensor
Humidity production in
cooking chamber on: No
water flows from the
pipes
(on the fans)
-
Incorrect connection to water mains
-
Connection of non-conforming pump
-
Check the connection to water
mains (electrovalve) or the
connection of pump
-
Cut-off cock closed (electrovalve)
-
Tank without water (pump)
-
Check the cut-off cock
-
Check water level into the tank
-
Blocked water inlet filter
-
Clean the filter
-
Electrovalve or pump water entrance
damaged
-
Contact a qualified technician to
repair the solenoid
Door closed: water /
vapour comes out of the
seal
-
Seal not fitted correctly
-
Check the seal fitting
-
Damaged seal
-
Contact a qualified technician to
repair the seal
-
Handle mechanism loosened (lateral opening
door)
-
Contact a qualified technician to
repair the prong
The oven does not cook
evenly
-
One of the motors is blocked or turns slowly
(If the oven has two motors)
-
Contact a qualified technician to
repair the motor
-
The motors do not go into reverse
-
Contact a qualified technician to
repair the motor
-
Heating element not powered or is damaged
-
Contact a qualified technician to
repair the element
Lighting lamp in the
cooking chamber does
not work
-
Damaged lamp
-
Change the lamp
-
Light bulb “unscrewed”
-
Make sure the light bulb is fully
screwed-in.