Tecno-gaz 250S2, User Manual

Page: 24 / 60

ENGLISH
22
PAR 06 ORDINARY AND EXTRAORDINARY MAINTENANCE

As for the external cleaning of the DISTILLER, you can use a neutral detergent and then dry.

Clean, if necessary, the gasket of the upper cover, but don’t remove it, it’s placed in a specific
direction (with the lip upwards)

The stainless steel internal chamber is delicate, don’t use abrasive detergents for cleaning
CLEAN THE MACHINE AT THE END OF EVERY CYCLE
1. Put hot water in the chamber just to cover the residues
2. Put from 1 to 4 teaspoons of detergent supplied inside the chamber, the quantity depends on
the residues.
3. With the chamber opened connect the feeding, bring to boiling the water and disconnect the
connection to the network
4. After 20 minutes drain the water and rinse with clean water
5. Repeat this operation until the chamber is completely clean
6. Little quantities of residue in the bottom don’t have to be considered harmful, the machine
works in effective way.
COOLING COIL
If the cooling coil is obstructed, the
effectiveness of the distiller could be
compromised.
For the cleaning, unscrew the screws (G) in
the part below the cover.
Remove the cover being careful during the
extraction to the joint in position (H).
Remove the coil and brush the cooling
commutators with care (I)

Don’t plunge the engine in the water
during the cleaning of the cover.

Add few drops of oil on the output
shaft in homogenous way.
FIG 5
FIG 6
I