EG
■
NON-REMOVABLE MOUNTING
•
Heat pump models
Install the remote controller at a convenient location on a
nearby wall. However, before attaching the remote controller
mounting cradle, check that the remote controller can operate
from the desired wall position. (Fig. 7-14)
•
Cooling only models
1)
Momentarily hold the remote controller at the desired
mounting position.
2)
Confirm that the air conditioner responds correctly when
you press keys on the remote controller from that
position.
3)
After confirming correct operation, use a screw-driver
to screw the mounting screw into the wall.
4)
Remove the remote control cover by sliding it downward.
5)
Remove the batteries of the remote controller.
6)
Use a screwdriver to screw the remote controller securing
screw into the wall through the hole in the battery
compartment. (Fig. 7-15).
7)
Replace the batteries.
8)
Again confirm that the remote controller operates
correctly.
Wood screw
(supplied)
Fig. 7-14
8. HOW TO INSTALL THE WEEKLY TIMER (Optional Controller)
WARNING
• Do not supply power to the unit or try to operate it until
the tubing and wiring to the outdoor unit are completed.
CAUTION
• Do not twist the control wiring with the power wiring
or run it in the same metal conduit, because this may
cause malfunction.
• Install the weekly timer away from sources of electri-
cal noise.
• Install a noise filter or take other appropriate action if
electrical noise affects the power supply circuit of the
unit.
■
ACCESSORIES
No
Accompanying parts
Quantity
Weekly timer
➀
1
Connecting wiring
length 1.2 m
➁
2
Screws M4 x 25
➂
2
Wooden screws
➃
2
No
Accompanying parts
Quantity
Spacer
➄
2
Clampers
➅
2
Operation manual
➆
1
Installation manual
➇
1
Switch box for 1 (no cover)
or switch box for 2 (no cover)
Spacer
M4 x 25
Screws (2)
Weekly
timer
Decorative
cover
Flat-top
screw
Under case
(Back case)
Control panel
Decorative
cover
Gap
Gap
Coin
30
ACL button
Fig. 7-16
Wall
Screw
(Packed in indoor unit)
7-12. How to install batteries (only for heat
pump models).
See fig. 7-16.
1)
Press and slide the lid on the back of the remote controller
in the direction of the arrow.
2)
Install two AAA alkaline batteries. Make sure the batteries
point in the direction marked in the battery compartment.
3)
Press the ACL button, then replace the lid. If you press it,
the current time, ON time, and OFF time are all reset to
0:00.
Fig. 7-15