TECHWOOD Beauty for Men TCO-2530, Instruction Manual

Page: 9 / 22

● Attachment comb #1 --- leaves hair approx.
Blending in length
●
Attachment comb #2 --- leaves hair approx. 1/4" in
length
●
Attachment comb #3 --- leaves hair approx. 1/2" in
length
●
Attachment comb #4 --- leaves hair approx. 3/4" in
length
●
Special angle comb is available.
● At the beginning, cut only a small amount of hair until you become
accustomed to the length each attachment comb leaves the hair.
●
It is suggested to try the longest attachment comb on the clipper first,
then use the shorter one if the desired length is shorter.
●
For uniform cutting, never push or force the clipper through the hair at
a fast rate. The clipper works most efficiently when it works at its own speed.
●
Start by combing the hair in its natural direction,
● Place the largest, attachment comb onto your clipper and start by
trimming the sides from the bottom upwards.
●
Hold the clipper lightly against the hair with teeth of the
attachment comb pointing up but flat against the head.
●
Slowly lift the clipper up and outward through the hair,
cutting only a small amount at a time.(Fig. 1)
●
Repeat around sides and back of head.(Fig.2)
● If you desire shorter hair, either change to a lower number
attachment comb or apply more pressure and less lift away from
head with the present attachment comb.
●
This entire procedure requires practice, and it is always
better to leave too much hair the first few haircuts.(Fig.3)
●
For the top of the head, you will give a fairly short cut if you
use the #4 attachment comb. With the teeth flat against the
head, slowly start trimming from the front to the back. Again, it is
better to leave the hair longer the first few haircuts.(Fig.4)
Outlining
● Outlining requires no attachment. Take the clipper and
push the lever up to the close-cut position.
●
Comb hair into the style. Position clipper between the side
burns and the ear.(Fig. 5)
●
Make sure the comer edge of the blade is against the
hairline. With the outline of the hair as your guide, slowly move
the clipper over, around, and behind the ears.(Fig.6)
9