TECHWOOD Beauty for Men TCO-2530, Instruction Manual

Page: 10 / 22

● For the back of the neck and the sideburns, hold the
clipper upside down, (see sketch), and holding it against the
skin at the length desired, move downwards.
Short cuts to perfect flat tops, crew cuts
● Always cut from the back of the neck to the crown,
using the longest attachment comb. Holding it flat against
the head, slowly move the clipper up through the hair.
●
Use the same technique for the sides, cutting from the
bottom to the upper side of the head. (Fig.7)
●
For the front to the crown, cut the hair against the
direction in which it grows. Then even it up with the
sides.(Fig.8)
●
For a flat top, use a flat comb, not the attachment
comb. Just cut hair on top of the head over it.
●
To taper hair down to the neckline, use closer cutting
attachment combs. Comb hair and check for uneven spots
and outline sideburns and neckline.(Fig.9)
If a short tapered cut on the sides and back is desired,
follow the diagram below:
The four basic areas illustrated on the hair cutting guide are your "road map" to
easy do-it-yourself hair cutting.
MAINTENANCE
● Your clippers were carefully examined to ensure that the blades
were oiled and aligned before leaving our factory.
●
Blades must be realigned if they have been removed for cleaning or
replacement.
●
To realign the blades, simply match the upper and
bottom blades teeth up, point for point.
●
(End of top blade teeth) should be approximately
1.2mm back from bottom blade.
●
Compare your clipper blades with the sketch)
● If blade alignment is incorrect, add a few drops of oil to
the blades, turn clipper on for a few moments, turn off and
unplug. Loosen screws slightly and adjust. Tighten screws
after blade is aligned.
10