132
Figure 4-46
4.7.2.2 Call PTZ Function
Call Preset
In Figure 4-41, input preset value and then click
to call a preset. Click
again to stop call.
Call Pattern
In Figure 4-41, input pattern value and then click
to call a pattern. Click
again to stop
call.
Call Tour
In Figure 4-41, input tour value and then click
to call a tour. Click again
to stop call.
Call Scan
In Figure 4-41, input Scan value and then click
to call a tour. Click again
to stop call.
Rotate
In Figure 4-41, click
to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
Preset, tour and pattern all need the value to be the control parameters. You can define it as you
require.
You need to refer to your cam
era user’s manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click
, system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 4-47.
Summary of Contents for NVR-ELT-16
