Technogym Unica Evolution, Service Maintenance Manual

Page: 50 / 60

UNICA EVOLUTION: Service & Maintenance Manual - rev. 1.1
Page 10.18
10.5. SERVICE: PERIPHERALS CHECK PANEL
To access this procedure, select the SERVICE item from the main configuration menu and enter the
password “
2501 ” which protects against unauthorized access. Use the two center keys to enter the
first password digit, then press OK ; proceed in the same way for the other digits. After pressing
OK to confirm the last digit, a new menu appears:
SERVICE
MACHINE CONFIGURATION
PERIPHERALS CHECK PANEL
CHECK/SET COUNTERS
Scroll down with the center keys until the PERIPHERALS CHECK PANEL item illuminates, then
press
OK . The display shows:
VISUALISE DATA
FRAME 127: 56: 3:240 412
DISL 412 DISM 0 2.5 KG
PINOUT N LOAD DW Y AW Y
This view is used for monitoring the status of the sensors and the serial communications between
the FPGA board and the CPU board (continuous transmission of 4 bytes from the FPGA board see
paragraph
Errore. L'origine riferimento non è stata trovata. ). The display shows:
•
1
st
LINE : shows the value of the 4 bytes of the communication protocol between the 2 boards,
in decimal format, separated by “:”. The last number is the selector pin position in
mm, obtained from the values of the 2
nd
and 3
rd
bytes;
•
2
nd
LINE : shows the following 3 values:
-
DISL : the selector pin position in mm, acquired during the last weight selection
before running the configuration procedure;
-
DISM : the relative displacement of the selector pin from its original position, in
mm, acquired before running the configuration procedure;
-
last selected weight before running the configuration procedure.
•
3
rd
LINE : readout of the machine status:
-
PINOUT : with the encoder currently used this value is always N ;
-
LOAD DW : shows the status of the weight stack: Y if the weight stack is in the
rest position, and N if the weight stack is raised. In other words, this parameter
monitors the state of the weight stack sensor;