Technogym Runrace, Service Maintenance Manual

Page: 150 / 184

RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 9.6
9.4. COMPLETE DISPLAY OF WORKING PARAMETERS
In order to check the state of wear of the machine and correctly carry out routine maintenance, a
special procedure is provided for viewing the working parameters. This is a “complete” procedure
in that the lubrication parameters shown are those pertaining to the duration and frequency.
To access this procedure, simultaneously press the
03 keys when the machine is in standby mode.
The following message appears on the LED matrix:
P A S S W O R D = 0 0 0 0
T H E N E N T E R O R C L E A R
Type in the password
2406 and press ENTER to confirm.
9.4.1. M
ACHINE UTILIZATION
The total hours of machine on-time and the total number of kilometers covered. The following
message appears on the LCD:
T O T A L H O U R S = X X X X
K m . C O V E R E D = X X X X
After 10 seconds, it automatically goes on to the next view.
The procedure can be aborted at any time by pressing the “Clear” key.
9.4.2. L
UBRICATION INTERVAL
The number of kilometers the machine must cover between one lubrication cycle and the next. The
following message appears on the display:
L U B R I C A T I O N T I M E .
K m . = X X X
After 10 seconds, it automatically goes on to the next view.
9.4.3. D
URATION OF AUTOMATIC LUBRICATION
The duration in seconds of an automatic lubrication cycle. The following message appears on the
LCD:
L E N G T H O F L U B R I C A T .
S e c . = X X X
After 10 seconds, it automatically goes on to the next view.
9.4.4. D
ISTANCE COVERED SINCE THE LAST LUBRICATION
The number of kilometers covered by the machine since the last automatic lubrication cycle. The
following message appears on the LCD: