RUN XT: Service & Maintenance Manual - rev. 2.0
Page 8.2
8.2.
TENSIONING A USED TREAD BELT
Figure 8.2-1
1.
After completing reassembly of the used tread
belt, lock down the rear right hand screw
a
until measurement
L
in Figure 8.2-2
corresponds to the value shown on the red
decal
b
on the inside of the rear right hand
cap.
2.
Lock down the left hand tread belt tensioning
screw until the drive roller is aligned with the
crosspiece.
Figure 8.2-2
Use a gauge to measure the distance
between the surface of the driven roller
and the outer edge of spacer c.
This procedure is normally carried out
after replacing the driving or driven
rollers, or in those cases where it is
necessary to reassemble the used tread
belt: it is not possible to carry out the
procedure as described in 8.1. because
the tread belt is not elastic.
After completing this procedure, check
the centering of the tread belt as
described in paragraph8.3. .
Summary of Contents for Run XT
