Technogym Bike Forma, Service Maintenance Manual

Page: 62 / 94

BIKE FORMA: Service & Maintenance Manual - rev. 1.0
Page 7.14
7.13. DISASSEMBLING THE BRAKE WINDING
Figure 7.13-1
Carry out the procedure described in paragraph
7.6. “Disassembling the guards”.
1. Unplug the two Faston connectors
a from the
winding.
2. Back off the fixing screws b on the machine
frame, using a 3-mm Allen wrench.
Figure 7.13-2
3. Place the winding assembly on a work bench.
4. Back off the two nuts
c using a 7-mm
wrench, locking down the 2 through-screws
from the opposite side using a 3-mm Allen
wrench.
5. Remove the assembly with the winding.
To reassemble the brake winding, carry out the
above steps in reverse order.
Be careful to position the brake
assembly so that the copper disk does
not brush against the laminated core,
using a 0.6-mm spacer.