Page 27 of 52
THIS MANUAL IS THE PROPERTY OF
TECHNOGEL SpA
–
ALL REPRODUCTIONS, EVEN PARTIAL, ARE FORBIDDEN
27
10.
In case of black-out during the cycle, the operator can manage product quality by controlling the relative
signals through the display. When power comes back, the machine restarts the cycle from where it was
interrupted. It is important for the operator to manage the situation respecting the correct health and
hygiene procedures and applicable laws.
11.
The mains current socket of the user must be protected by a residual current device calibrated at 300
mA and by an adequate circuit breaker.
12.
Wait 15 seconds for the residue static charge to be discharged if it is necessary to access the inverter of
the electric motor or compressor, during maintenance.
13.
There is a risk of electrocution due to the presence of cables and electric clamps, if accessing the
machine internal parts without disconnecting power.
4.5
PERSONAL PROTECTIVE EQUIPMENT TO BE USED
Wear suitable protective equipment for the operation to be carried out, if having to access the machine work
area.
-
Clothing must be tight-fitting.
-
Avoid wearing ties, necklaces or belts that might get tangled in moving parts.
-
When required, properly tie-up hair to avoid it getting tangled up between moving parts.
ATTENTION
The authorised operators and/or maintenance technicians must wear the following
personal protective equipment before starting work on the machine.
Tight-fitted protective clothing.
During all work and maintenance phases.
Protective gloves.
During the manual wok phases (product/tools load
and unload) and maintenance.
Accident-prevention footwear.
During all work and maintenance phases.
Tab. 4-2
NOTE
The clothes to be worn and protective equipment to be used must meet the requirements of
Directive 89/686/EEC with regard to personal protective equipment
4.6
SIGNAL PLATES PRESENT ON THE MACHINE
ATTENTION
There are different signal and/or danger plates, shown below, applied on the machine, on
the protections and in the different productive cycle areas. The plates are used to warn
personnel authorised to intervene on the machine on any dangers, obligations or
prohibitions to be observed to avoid dangerous situations for the operators and for any
exposed people, and for the machine itself.
