TechniSat TECHNIRADIO 3, Instruction Manual

Page: 59 / 119

116 117
DE
EN
DA
NL
11 Troubleshooting
If the device does not operate as intended, check the table below for information.
Symptom Possible cause / remedy
The device cannot be switched on. The device is not being supplied with power.
Connect the power supply unit correctly to the
socket and to the device. Replace flat batteries.
No sound can be heard. Increase the volume.
The display does not switch on. Disconnect the device from the mains supply /
briefly remove the batteries and reconnect the
device to the mains.
Poor reception via DAB+ / FM. Fully extend the antenna. Change the position of
the antenna or the TECHNIRADIO 3.
The device cannot be operated. Disconnect the device from the mains supply /
briefly remove the batteries and reconnect the
device to the mains.
If the malfunction has not been resolved, even after performing the checks described,
please contact the Technical Hotline.
12 Technical specifications / manufacturer's instructions
Subject to technical changes and errors.
Reception channels DAB / DAB+, FM
Power supply AC Input: 100-240 V, 50 / 60 Hz
DC Output: 5.9 V / 1 A
Frequencies USW: 87.5-108 MHz
DAB / DAB+: Band III 174-240 MHz
Power consumption (mains mode) in operation max.: 3.1 W
Standby: 0.81 W (with time / date)
Audio output 1.3W RMS @ 1kHz 5 % THD
Weight 238 g (without batteries)
Dimensions (W x H x D) 150 mm x 95 mm x 50 mm