TechniSat TECHNIRADIO 3, Instruction Manual

Page: 58 / 119

114 115
DE
EN
DA
NL
> Using the <Tune or Tune> buttons, select the [Yes] item to run the factory
setting and press the Select button.
All previously stored stations and settings will now be deleted. The device is now
in the same status as when delivered.
> The display will show [Restart ...] and the device will start using the language
selection: [Language] . Using the <Tune or Tune> buttons, select one of the
available languages and confirm the selection by pressing the Select button.
The device then automatically performs a complete scan in DAB mode. While
scanning, the display information shows the progress as well as the number of
digital radio stations detected. After completing the station scan the first DAB+
channel is played.
9.7 SW version
Under SW version you can retrieve the currently installed software version.
> In the sub-menu [System] , use the <Tune or Tune> buttons to select the [SW
version] entry, and then press the Select button.
The current software version is displayed.
10 Cleaning
To prevent the risk of electric shock, you must not clean the device using a wet
cloth or under running water. Prior to cleaning, disconnect the mains plug and
switch off the device!
You must not use scouring pads, scouring powder, or solvents such as alcohol or
petrol.
Do not use any of the following substances: Salt water, insecticides, solvents
containing chlorine or acids (ammonium chloride).
Clean the housing using a soft, damp cloth. Do not use spirit, thinners, etc.; you
could damage the surface of the device.
Only clean the display with a soft, cotton cloth. If required, use a cotton cloth
with small amounts of non-alkaline, diluted, water-based or alcohol-based soap
solution.
Gently clean the surface using the cotton cloth.