TechniSat SKYRIDER 65, Instruction Manual

Page: 49 / 172

49
DE
EN
FR
IT
NL
PL
> Connect the power supply cable to the on-board power supply of your vehicle following the labels on the cables and
then connect it to the power supply of the controller (see point 4.4.3).
> Press the Set button on the controller.
The dish arm will now start up automatically and the system will begin to turn.
> Disconnect the power supply as soon as the dish arm is upright.
> Attach the dish to the dish arm and screw it in the upper holes using the M6x15 screws and in the lower holes with the
M6x25 screws. Also use a washer for each screw.
> Attach the LNB arm to the bottom of the dish arm and screw it on using the M6x55 screw.
> Connect the coaxial cable(s) protruding from the LNB arm to the LNB jack(s) on the alignment unit and slide the
grommet(s) all the way up.
> Attach the coaxial cable using the cable clamps.
> Apply the protective sticker in front of the satellite connection of the alignment unit at a distance of 11cm (see illustration
under point 4.4.1).
> Restore the connection to the power supply.
The satellite system is now ready for use.
Ignition