TechniSat SKYRIDER 65, Instruction Manual

Page: 48 / 172

48
> Set the cable holder onto the previously marked position and drill the 3 holes with the 2mm drill bit through the cable
holder for screwing to the vehicle roof.
> Screw the cable holder to the roof with the 4x16 screws.
> Remove the tape, apply a thin seam of mounting adhesive around the edge of the cable holder and over the screws and
smooth it off.
> Push the rubber seal into the cable screw connection and unscrew the screw cap.
> Connect the satellite cable to the satellite system jack and the control cable to the controller port (see connection
diagram point 4.4.3).
> Connect the STB connector to the antenna jack of a satellite receiver / TV set with built-in receiver using the STB cable
(see connection diagram point 4.4.3).
48