TechniSat DIGITRADIO Car 2, Instruction Manual, Page: 78 / 84

78
The status light on the reception unit
is flashing.
The DIGITRADIO is not connected to
your vehicle.
Make sure that the connection cable is
properly connected to the audio system
in your vehicle and check whether the
correct FM frequency is set.
The input source for the audio system in
your vehicle is not correct.
Change the input source in your vehicle’s
audio system to FM radio or the AUX
input.
The DIGITRADIO will not connect to the
mobile device in Bluetooth mode.
Activate Bluetooth on your mobile device.
If necessary, pair the DIGITRADIO with your
mobile device again.
The volume in your vehicle or on your
connected mobile device is set too low.
Increase the volume in your vehicle and
on the connected
mobile device.
When the DIGITRADIO is connected by
a cable, the sound is distorted.
The amplifier setting in cable mode is
incorrect.
Set the amplification (Item 6.1) of the LINE
OUT to “LOW” or switch to FM transfer.