TechniSat DIGITRADIO Car 2, Instruction Manual

Page: 77 / 84

77
DE
EN
The display/control unit shows
“CONNECT ANTENNA” or “CHECK
POWER TO ANT.".
The reception unit is not connected to
the power supply, or the display/control
unit is not paired correctly with the
reception unit.
Remove the power adapter from the 12 V
socket and re-insert it. If the reception unit
is being supplied with power, its status
light comes on for 5 seconds and the
display/control unit makes contact with
the antenna within 30 seconds. Note: If
you cannot access the power adapter,
perform a re-start*.
If this does not solve the problem, connect
the display/control unit to the reception
unit:
1. Press the reset button on the reception
unit with a paper clip. The status light on
the reception unit flashes slowly.
2. Position the display/control unit at a
maximum distance of 50 cm from the
reception unit, and hold down the
and buttons together.
Repeat Steps 1 and 2 if the control unit
does not connect to the antenna within
30 seconds.
The status light on the reception unit
is constantly lit up.
The DIGITRADIO is in update mode. If you are updating the software, cancel
the update. If not, remove the power
adapter from the 12 V socket and re-insert
it. If the reception unit is being supplied
with power, the status light comes on for
5 seconds and the display/control unit
makes contact with the reception unit
within 30 seconds. Note: If you cannot
access the power adapter, perform a re-
start*.