9
default is °C. After clicking ”°C/°F” to select the temperature unit of the
machine, the next time the machine is turned on will default to this unit,
and the machine has a memory function.
6. Click ”TEMP /TIME” to select the temperature or time to be adjusted, and
set the target value with the ”+” and ”-” keys.
7. After the setting is completed, click ”Start/Stop” to make the machine start
working.
8. When the temperature reach to the set temperature, the machine will beep,
then press ”Start/Stop” button, it will count down.
9. After the cooking is finished, the machine will beep. Click ”Start/Stop” to
finish the machine work.
Note: If there is no operation, the machine will emit a continuous beep after
20S, while the water temperature will remain at the preset temperature.
10. Take foods out, then the food is ready for afterward process.
11. After using the machine, cut off the power supply. Store the machine at the
place out of the children’s contact.
Note:
1. Before Sous Vide cooking, the food must be vacuum packed first.
2. The water level (after the food is put in) should be higher than the ”MIN”,
but lower than the ”MAX” marked on the machine.
3. To avoid the machine from aging, drain the water after use and clean the
water bath.
9. Maintenance
To avoid burning, please make sure that the machine is power off and cool
down to room temperature before cleaning.
1. Place the machine vertically after cleaning, do not place it horizontally or
upside down.
2. During cleaning, do not damage the components inside the machine. Once
the components are damaged, please ask specialist to check and repair. Do
not attempt unauthorized repairs to avoid accidents.
3. Abandon old water after each use, and fill with fresh water next time. If the
water is reused many times, some mineral substance may subside or adhere
to the surface of the components, thus influence the machine performance.
When you notice the discharge capacity reduce obviously or the machine’s
components have much ash and dirts, Please disassemble the low part
of the machine’s housing(Please refer to the below ”How to Disassemble
Quickly”) to clean the heat tube and probe , it is better to clean every 20
times or 100 hours working.
