1000BASE-T1 MediaConverter EMC
User Manual
6
2
HARDWARE INTERFACES
2.1
Connectors
On the label on top of the device you can see an overview about all HW-Interfaces of
the 1000BASE-T1 MediaConverter_EMC.
2.1.1
MATEnet Connectors
The pinning of the ECU connector is shown on the label on top of the device as well.
(See
Fehler! Verweisquelle konnte nicht gefunden werden.
).
The left MATEnet connector is for power supply.
The right MATEnet connector is for BUS connection to the device under test (DUT).
Warning
: If you apply a voltage higher than 18 Volt, the device will be damaged!
Figure 2
—
1: Label of 1000BASE-T1 MediaConverter_EMC with pinning information
