7
Control Panel Menu Table
The following table describes the control panel’s menu options and settings. What is
displayed on the screen is marked in “quotations”. When this unit powers up, it will
display “SYON” for System Power On.
Note:
MODE will not show up in the control panel menu system. To enter the MODE
options, before applying power, you must hold down the MENU button for 6 seconds
while the unit is powering up. The factory default MODE is set to “04”, the 6 channel
DMX mode.
DMX-512 Control
Fixtures require a "Start Address" from 1 to 512, setting the first DMX channel containing data
for the fixture (see DMX Background). Before addressing fixtures, consult the manual of the
system’s DMX controller to select a desirable addressing scheme. Valid Start Addresses range
from 1 to 512. Fixtures requiring more than one channel for control will read subsequent
channels up to the total number of channels required. Since this fixture requires a maximum of
6 channels of DMX, if set to a Start Address of 7 it would use data from channels: 7 and 8, 9,
10, 11, 12. Choose a Start Address so the channels used do not overlap with other fixtures. In
some cases, it may be desirable to set two or more same type fixtures to the same Start
Address. In this case, the fixtures will be slaved together and respond to the same data.
Because all fixtures see the same data, fixtures may be set to any address without concern for
the order they are connected by the DMX cables.
Note:
For DMX to operate on this unit, all STANDALONE options must be set to Off.
Menu Options
Function
Options
MODE
“MODE”
Select Number of DMX Operating Channels
01 = 3ch, 02 = 4ch, 03 = 5ch or 04 = 6ch
ADDRESS
“ADDR”
Select DMX Start Address
1-512
COLBALANCE
“COBA”
Enable/Disable Color Balance preferences
BALANCE “BAL”
: Off or On
“RGB”
- Set individual values for the Color
Balance: R 0-255, G 0-255, B 0-255
DISPLAY
“DISP”
Set the Display Backlight
Off or On
MANUAL
“MANL”
Manual Operation Options
RESET “RESY”
TEST
“TEST”
: Test the individual Colors: R
0-255, G 0-255, B 0-255
PROGRAMMER “PROG”:
SCENE “SCEN”: 16 user
programmable scenes: SC0
1-16 set R
0-255, G 0-255, B 0-255, Strobe 0-255
CHASE “CHAS”: 6 user
programmable chases:
CA01-06 set
Speed S000-255
STANDALONE
“STAL”
Functions for
Automated Run Options
SOUND “SOND”
: Off or 001 – 100
MASTER “MAST”
: Off or On
SLAVE “SLAV”
: Off or 001-031
PLAYBACK “PLAY”
: Scene SC01-16 or
Chase CA01-06
