EDM1-IMX6 HARDWARE MANUAL
– VER 1.00 – NOV 14 2019
Page
61
of
80
3.17.3. Power Sequencing for ATX based configurations
EDM1-IMX6 input power sequencing requirements for ATX based configurations are as follow:
If a backup RealTime Clock (RTC) is required in the host system. We recommend to design an RTC
circuit on the EDM carrier board. For example the Maxim Integrated connected over the general
purpose I
2
C can be used.
Start Sequence:
Optional VCC_RTC must come up at the same time or before 5VSB comes up.
5VSB must come up at the same time or before VCC comes up.
A 5V return signal is generated on EDM PIN# 251
PWGIN must be active at the same time or after VCC comes up.
Stop Sequence:
PWGIN must be inactive at the same time or before VCC goes down
VCC must go down at the same time or before 5VSB goes down
5VSB must go down at the same time or before VCC_RTC goes down
Table 39 - Input Power Sequencing for ATX based configurations
Item
Description
Value
T1
VCC_RTC rise to 5VSD rise
≥ 0 ms
T2
5VSB rise to VCC rise
≥ 0 ms
T3
VCC rise to PWGIN (S3) rise
≥ 0 ms
T4
PWGIN (S3) fall to VCC fall
≥ 0 ms
T5
VCC fall to 5VSB fall
≥ 0 ms
T6
5VSB fall to VCC_RTC fall
≥ 0 ms
Figure 13 - Input Power sequence for ATX based configurations
