10
USB Extender Mounting
Optional Ethernet Pass Through Connection
The bottom of the TL-FO-USB3-02 enclosures features four pre-drilled holes for optional surface mounting.
Distance between the enclosure mounting holes: 42.0 mm x 205.5 mm
1. Mark the center point of each of the four holes on your mounting surface either by directly measuring or using
a print out of the stencil on the following page.
2. Hardware recommendation: M3.0 locking washers and M3.0 screws (4 of each per extender) noting screw
length will depend upon thickness of mounting surface.
3. Drill through each of the four hole markings on the mounting surface using a 3.97mm (5/32”) drill bit.
4. Align the bottom enclosure holes to the newly drilled out holes on the mounting surface.
5. Place a locking washer on each of the four screws and using a screwdriver, fasten the extender into place.
mounting hole
The TL-FO-USB3-02 offers a 100 Mbps Ethernet pass through connection that can be used for a variety of
purposes including:
• Connecting network devices
• Providing Client network access to the same location as the Client Extender
• Leveraging existing cabling to provide USB 3-2-1 connectivity without losing network connectivity
Connect any network device or access port into the RJ45 socket label “LAN” using up to 100 meters of standard
CAT 5e, 6 or 7 cabling.
Do not exceed a screw depth of 10mm (0.4”) into the unit or damage may occur.
