Page 25 of 40
Actuator with IC
I/O specifications:
Input/Output
Specification
Comments
Violet
Analogue feedback:
Configure any high/low combination
between 0-10V or 0.5-4.5V
0-10V (Option A)
0.5-4.5V (Option B)
Tole/- 0.5V
Max. current output: 1mA
Ripple max. 200mV
Transaction delay 100ms
Linear feedback 0.5%
It is recommendable to have the
actuator to activate its limit switches
on a regular basis, to ensure more
precise positioning
Single Hall output (PNP)
Movement per Single Hall pulse:
3mm pitch = 0.38mm per pulse
5mm pitch = 0.63mm per pulse
9mm pitch = 1.13mm per pulse
12mm pitch = 1.5mm per pulse
Frequency:
Frequency is 30-125 Hz on Single Hall
output depending on load and spindle.
Overvoltage on the motor can result in
shorter pulses.
Output voltage min. V
IN
- 2V
Max. current output: 12mA
Max. 680nF
N.B. For more precise measurements,
please contact
LINAK A/S.
Low frequency with a high load.
Higher frequency with no load.
White
Ready
The signal is constantly high when
the actuator is in ready mode.
Failure modes:
The signal goes low when:
- The current cuts off
- The temperature is out of range
(high duty cycle protection)
The high duty cycle protection is NOT to be used as a stop function, since this might damage the
actuator!
