Page 18 of 40
Actuator with potential free endstop signals and relative positioning -
Single Hall
I/O specifications:
Input/Output
Specification
Comments
Description
The actuator is equipped with potential
free endstop signals and Single Hall that
gives a relative positioning feedback signal
when the actuator moves.
See connection diagram,
fig. 4, page 17
Brown
12-24VDC (+/-)
12V ± 20%
24V ± 10%
Under normal conditions:
12V, max. 10A depending on load
24V, max. 5A depending on load
To extend actuator:
Connect Brown to positive
To retract actuator:
Connect Brown to negative
Blue
To extend actuator:
Connect Blue to negative
To retract actuator:
Connect Blue to positive
White
Signal power supply (+)
10-28VDC
Current consumption:
Max. 40mA, also when the actuator is
not running
Black
Signal power supply GND (-)
Green
Endstop signal out
Output voltage min. V
IN
- 2V
Source current max. 100mA
NOT potential free
Yellow
Endstop signal in
Violet
Single Hall output (PNP)
Movement per Single Hall pulse:
3mm pitch = 0.38mm per pulse
5mm pitch = 0.63mm per pulse
9mm pitch = 1.13mm per pulse
12mm pitch = 1.5mm per pulse
Frequency:
Frequency is 30-125 Hz on Single Hall
output depending on load and spindle.
Overvoltage on the motor can result in
shorter pulses.
Output voltage min. V
IN
- 2V
Max. current output: 12mA
Max. 680nF
N.B. For more precise measurements,
please contact
LINAK A/S.
Low frequency with a high load.
Higher frequency with no load.
Red
Potential free signal power supply (+)
10-28VDC
Switching capacity:
Minimum 10mA
Maximum 1A
