I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
7
Operator's guide
7. FILLING AND EMPTYING THE BASIN
1.
2
3.
8. CONNECTION TO THE MAINS
1
(A)
2
3
4
5
9. CONTROLS
1. Thermostat:
2. Basin resistor switch:
3. Heating lamp switch:
4. Water level alarm
5. Cover lifting switch:
N.B.:
10. CHECKING CORRECT OPERATION
Make sure that: 1.
2
3
4
5.
6
7.
8.
11. CLEANING OF THE BAIN-MARIE BASIN
1
2
3
4
5
The basin must be filled manually, taking care not to fill above the level indicated on the basin walls.
. The machine gives an acoustic warning signal to advise you when water must be added to the basin.
To empty the basin, open the tap fitted to the rear side of the machine.
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
attached
to the appliance. . Ensure that the supply socket:
. Ensure that
there is no danger of explosion (AD) in the room. . Make sure the environment is suitable for the power
supply cable provided. The cable of the appliance is H05 VVF, designed for internal use. . Insert the plug
in the socket (do not use three-way adapters and reduction adapters).
The appliance features controls situated in a protected panel on the front side.
to adjust
the temperature in the appliance.
to switch on the resistors of the bain-marie
basin.
to switch on the heating lamps.
, signalling when
water must be added.
to open and close the cover - Position II to lift - Position O
to stop - Position I to lower
turn the heated shelves and heating lamps off ten minutes before
lowering the cover (see fig. 7).
the plug is connected; . cover is open; . bain-marie resistor switch is on (green light
lit up); . heating lamps are on;
water level in the bain-marie basin is within the limits. . Remove any
obstructions in front of the float hole.
Check that the set temperature is correct.
Keep the machine
away from inflammable material or any danger of explosion.
. Turn off the power switch and pull the plug out of its socket. . Open the tap on the rear side of the
machine. . Clean the basin walls with a sponge dipped in water and sodium bicarbonate. . Carefully dry
each item with a dry, clean cloth. . Turn the tap off and reconnect the appliance to the power supply.
a) is properly earthed; b) fulfils the requirements of the
rated current as set out on the rating plate; c) complies with the IEC regulations:- thermal-magnetic switch
with In = rated value as stated on the rating plate; - differential with Id sensitivity = 30 mA.
