Explanation of symbols in
Fig.R
1. Tubing clampscrews
2. Screws for cover
3. Nuts holding motor
4. Capacitor
5. Thermostat
6. Thermostat body
7. Air pump
8. Plastic screw for adjust-
ting of airflow
9. Air pump membrane
10. Screw to be unscrewed
before changing mem-
brane
11. Nut holding watertank
12. Screws to be loosened
before removing water
tank
13. Nut for thermostat body
14. Nutfor heating element
15. Heating element
16. Cableconnection on
thermostat
17. Nut for thermostat
18. Screw holding water
pump housing
19. Watertank
f) Remove the cable connections.
g) Remove the nuts holding the element (Fig. R, pos. 14).
h) Replace the element (Fig. R, pos. 15). Make sure that the
sealings are inside the tank.
Vl:5. REPLACEMENT OF THERMOSTAT
a) Follow the procedure Vl:4, a—e.
b)
c)
d)
Disconnect the two cables on the thermostat. (Fig. R, pos.
16).
Remove the nut on the thermostat. (Fig. R, pos. 17).
Replace the thermostat and reassemble the Service Unit.
Fig.S
2.
3.
4.
5.
6.
7.
Explanation of symbols
1. Front part of pump hou-
sing
O-ring
Pump rotor
Centre screw to pump ro-
tor
Screw holding rear part of
pump housing
Screw holding the shaft
seal
Shaft seal
15
Summary of Contents for Soxtec System
