tecan Balance Kit for SAG 285/01, Operating Manual, Page: 5 / 40

1 - About This Manual
Balance Kit V4.7, Operating Manual, 393278, en, V1.0 1 - 1
1 About This Manual
Purpose of This
Chapter
This chapter points out the purpose of the manual, specifies the product the
manual deals with and who the manual is intended for. Furthermore, it explains
the symbols, conventions and abbreviations used and offers other general
information.
Purpose of This
Manual
This manual describes the Balance Kit SAG 285/01and provides all information
required for the proper installation and setup of the kit as a preparatory step for
the Gravimetric Test. In addition, it provides the necessary references to the
document(s) where the Gravimetric Test is described in detail.
Target Group This manual is addressed to advanced users and authorized field service
engineers (FSEs) who wish to run the Gravimetric Test on instruments that are
equipped with a liquid handling arm (LiHa).
Scope This Operating Manual is limited to the following:
Š Applicable to the installation and setup of the Balance Kit for the Weighing
Module SAG 285/01 from Mettler Toledo AG.
Š Software for Gravimetric Test: Instrument Software, version 4.2 or later.
Symbols and
Conventions
Š Cross-references appear as follows: e.g. “Refer to section 1.1.1, 1-1 ”
– 1.1.1 refers to the corresponding chapter number.
– The symbol denotes the “page number”.
– 1-1 refers to the page number, whereas the first number stands for the
chapter number (chapter 1 - page 1).
Š Command Sequences for functions of the Instrument Software are printed in
bold type, e.g. Select Liquid System > Balance.
Note: The symbols pertaining to safety (WARNINGS and ATTENTIONS) are
explained in Chapter 2 “Safety”, 2-1 .
For Your Safety Before performing any work on or with the Balance Kit, first read the
Operating Manual carefully, in particular chapter 2 “Safety”.