6-53
6. DIAG. TEST OPERATION
EM18-33011
NOTES: 1. Total media distance covered (TL FEED) and the adjustment value for the sensors cannot
be cleared.
2. Data stored on the flash memory card cannot be cleared with this procedure. To clear data
on the flash memory card, send the format command to initialize the card. For details, refer
to the External Equipment Interface Specification.
3. For data to be cleared in the RAM clear mode, refer to the RAM clear mode table.
4. After RAM clear is performed, the threshold setting value will turn to the default (0). When
using pre-printed labels, be sure to set the threshold after referring to the Owner's Manual.
(Revision Date: Dec. 10 '99)
6.6 RAM CLEAR MODE
Mode Name
Function
PARAMETER CLEAR
Item
Print tone fine adjustment
(Thermal direct) (KEY)
X axis fine adjustment
Character code selection
Font zero selection
Control code selection
Ribbon type selection
Ribbon motor drive voltage fine adjust-
ment (PC)
Ribbon motor drive voltage fine adjust-
ment (KEY)
Strip wait status setting
Status response
Threshold manual fine adjustment for the
black mark sensor
Threshold manual fine adjustment for the
feed gap sensor
Label pitch
Effective printing length
Effective printing width
With/without ribbon
Sensor type
Feed Speed
Issue mode
PC save automatic calling
Kanji code
EURO font code
Transmission Control Mode
Reset selection when the
INPUT • PRIME signal is ON.
Initial Value
0 step
0.0 mm
PC-850
"0"
(without slash)
Auto.
Trans.
0
0
1
ON
1.0 V
1.4 V
76.2 mm
74.2 mm
80 mm
with
Transmissive sensor
(Feed gap sensor)
5 inch/sec.
Standard
(Batch printing)
ON
TYPE 1
B0H
DTR
ON
