TEC 710, Installation Manual

Page: 6 / 16

6
TEC-61157-1 Installation Manual-700/710 USB
Pin #5.
"
Stop signal control
"
. Used if there is no information in CAN bus
about brake pedal state (check Integrator). Input #5 connect to the
end switch of the brake pedal.
Pin #6, 14. Data bus CAN-L, CAN-H. Connects to the CAN bus of the
vehicle (check Integrator).
Pin #7.
"
Engine lock
"
. Connects to the relay that is used to prevent the
engine from launching.
Pin #8.
"
Ground
"
. Connects to the vehicles body in the area determined
by vehicle manufacturer for OEM connection.
Pin #11.
" Turn signals alternate control " . Used to
control hazard lights in vehicles where CAN bus is not avaliable. For list
of vehicles that require this connection please refer to Integrato
Pin #13.
"
Hood state control
"
. Used if CANBus contains no information
about hood state.
Pin #15.
" Siren control / Horn control " . Required algorithm
is set when installing the Alarm .
Pin #16.
"
Power
"
. It is connected through 3A fuse to
any non-sw12V circuit.
CAN bus parameters indication
Geature shown following parameters:
• Hood, trunk, doors (each door individually)
• Ignition switch state (key presence, АСС, IGN, Start)
• Engine is running
• Gearbox state (for automatic – P, R, N, D; for manual – R)
• Parking brake
• Stop-signal
• Security
• Factory security system alert
• Central lock state
• Sensors ignore
• Engine RPM
• Engine temperature
Feature allow quickly check vehicle state and adjust connection
if required. Buit-ib LED is used for indication (check
"
Connection
scheme
"
). LED lights up if any parameter is selected and stays for 5
seconds or until other parameter is chosen.
"
Engine RPM
"
and
"
Engine temperature
"
will be indicated if no
other parameters are chosen:
" Engine RPM " — LED flashes with frequency proportional to the RPM:
1 flash per second equals 500 RPM of the engine.
"
Engine temperature
" — LED flashes 1 time every time new data
received (with ignition or or the engine running).