Team SILK SX28-72, Instruction Manual

Page: 22 / 93

SX28-72 Flange Facing Machine
21
4.2 BASIC OPERATION OF THE EQUIPMENT
The basic operation of the machine follows the routine:
1. Lifting the machine from its packing case.
2. Checking the machine for completeness and condition.
3. Fitting the appropriate base assembly to the work piece.
4. Lifting and positioning the machine on the base assembly.
5. Adjusting the machine so the surfacing arm is parallel with the work piece.
6. Balancing the machine if being used in a vertical orientation.
7. Connecting the air supply and setting the rotational speed.
8. Setting the tool for facing and grooving.
9. Performing the machining operation.
10. Removal of the machine on completion and preservation and packing.
4.3 LIFTING AND SLINGING ARRANGEMENTS
The SX28-72 machine when complete and, in its packing, box weighs 516 kg.
DO NOT ATTEMPT TO MANUALLY MOVE THE MACHINE IN ITS PACKING BOX. ALWAYS
USE A MECHANICAL LIFTING DEVICE.
DO NOT ATTEMPT TO MANUALLY LIFT THE SX28-72 MACHINE OR BASE OUT OF THE
PACKING CASE. ALWAYS USE A MECHANICAL LIFTING DEVICE.
WHEN SETTING UP THE MACHINE ON A VERTICAL FLANGE THE LIFTING CHAIN
SHOULD BE LEFT IN PLACE UNTIL THE MACHINE IS FULLY SECURED.
Before machine installation, as a secondary precaution, it is recommended that a framework
is constructed inside the vessel to support or restrain the base to prevent injury to the operator
and possible damage to the equipment should the machine slip or move within the bore.
When working on vertical vessels it is advisable to erect staging under machine base to aid
with installation and positioning, and to prevent base from falling into vessel.