41
58
43
70
58
69
85
68
80
BAG D (Continued)
16
Step D-10
Figure 36
Step D-11
Figure 37A
Step D-12
Figure 38
Figure 37B
The "Foam Things" are primarily for use on dusty, out-door
tracks and surfaces. Their use is left to your discretion.
q
1. Place a "Foam Thing" (85) over the Ball Stud (68) located in the
top of the Spindle Carrier (80). Place a second "Foam Thing" over the
Ball stud (155) located in the Shock Tower (69).
q
2. Snap the end of the Turnbuckle assembly with the Right-Hand
Threads to the Ball Stud in the Spindle Carrier. Snap the other end to
the Ball Stud in the Shock Tower.
q
3. Repeat Steps 1-2 to attach the other Turnbuckle assembly to
the Right Spindle (70) assembly.
Assure that the right-hand threads on the turnbuckle are lo-
cated towards the outside of the chassis for easier adjustment later.
q
1. Thread a Plastic Rod End (58) onto each end of a 1" Titanium
Turnbuckle (89). Tighten both Rod Ends equally until the Tierod is
the same length as the assembled Tierod in Figure 37B. Make two of
these assemblies.
Each end of the Turnbuckle is threaded opposite. One end
has right-hand threads, the other has left-hand threads. This allows
the length of the rods, once installed, to be adjusted without remov-
ing them.
58
q
1. Snap the end of the Turnbuckle assembly with the Right-Hand
Threads to the Ball Stud (43) in the Left Spindle (70). Snap the other
end to the Ball Stud in the Left Bellcrank (41).
q
2. Repeat step 1 to attach the other Turnbuckle assembly to the
Right Bellcrank (42) and the Right Spindle (70).
Turnbuckle - Camber Link Install
Turnbuckle - Steering Link Assembly
Turnbuckle - Steering Link Install
89
89
58
