ii
Team Losi is continually changing and improving designs; therefore, the actual part may appear slightly different than the illustrated part. Illustrations of parts and assemblies
may be slightly distorted to enhance pertinent details.
TOOLS REQUIRED FOR ASSEMBLY
Team Losi has supplied all necessary Allen wrenches and a special wrench that is needed for assembly and adjustments. The following com-
mon tools will also be required: Needle-nose pliers, regular pliers, hobby knife, scissors or other body cutting/trimming tools, and a soldering
iron may be necessary for radio installation. 3/16”, 1/4”, 5/16”, and 11/32” nut drivers are optional.
RADIO/ELECTRONICS
A suggested radio layout is provided in this manual. Your high performance R/C center should be consulted regarding specifi c questions
pertaining to radio/electrical equipment.
HARDWARE IDENTIFICATION
When in question, use the Hardware Identifi cation Guide at the back of this manual.
For screws, the prefi x number designates the thread size and number of threads per inch (i.e., 4-40 is a #4 size thread with 40 threads per
inch). The second number, or fraction, designates the length of the screw. For cap head and button head screws, this number refers to the
length of the threaded portion of the screw. For fl at head and set screws, this number refers to the overall length of the screw.
Bearings and bushings are referenced by the inside diameter (I.D.) x outside diameter (O.D.). Shafts and pins are referred to by diameter
x length.
Washers are described by inside diameter or the screw size that will pass through the inside diameter x the thickness of the washer.
E/C-clips are sized by the shaft diameter that they attach to. The Hardware Icon associated with E/C-Clips only designates the part genre
of clips, not the actual part.
Nuts come in four types, Non-Flanged, Flanged (F), Plain, and Locking (L) (designated on the Hardware Icons). The prefi x number desig-
nates the thread size and number of threads per inch. The second number, or fraction, designates the size of the hex. For example, L 4-40
x 1/4” designates a Lock nut that will thread onto a 4-40 screw using a 1/4” nut driver.
Ball studs are described by the length of the neck between the base and the bottom of the ball (i.e., standard, short) and the length of the
threaded portion. A female ball stud is also used, this has internal threads similar to a nut.
•
•
•
•
•
•
TABLE OF CONTENTS
SECTIONS
1.
INTRODUCTION
..................................................
i
Kit/Manual Organization ...................................
i
Important Safety Notes ......................................
i
Tools Required for Assembly ............................
ii
Radio/Electronics ..............................................
ii
Hardware Identifi cation ....................................
ii
2.
Bag A:
Main Chassis ........................................... 1-3
3.
Bag B:
Drivetrain ................................................ 4-6
4.
Bag C:
Front Suspension ..................................... 7-9
5.
Bag D:
Rear Suspension .................................. 10-12
6.
Bag E:
Shocks ................................................. 13-14
7.
Bag F:
Final Chassis/Electronics ..................... 15-19
8.
Checklist Before Your First Run
........................20
9.
Setup Guide
.................................................... 21-23
10.
Blank
JRX-S
Setup Sheet
....................................24
11.
Hardware Identifi cation Guide
...........................25
12.
Filled-out
JRX-S
Kit Setup Sheet
.......................26
TABLES
Table 1:
JRX-S Completed Kit Specifi cations .............
i
Table 2:
Servo Installation ...........................................1
Table 3:
Motor Gearing and Rollout ..........................21
INTRO
