![background image](http://html1.mh-extra.com/html/team-losi/bk2/bk2_owners-manual_4004840022.webp)
BAG D (Continued)
18
Step D-14
Slipper Clutch Assembly:
q
1. Slide the Slipper Backing Plate (104) over the Top Shaft (90), aligning the flat sections on the Top Shaft (90) with the flat sections of the
Slipper Backing Plate.
q
2. Place the Slipper Pad (105) on one side of the 78 tooth Spur Gear (106) and align the notches on the Spur Gear with the notches on the
Slipper Pad.
q
3. Place the Spur Gear, Pad side first, over the Top Shaft. The Slipper Pad should rest against the Slipper Backing Plate.
*NOTE: Ensure that the Slipper Pad remains indexed in the Spur Gear.
q
4. Install the second Slipper Pad to the exposed side of the Spur Gear. Again, align the notches on the Spur Gear with the notches on the
Slipper Pad.
q
5. Place the second Slipper Backing Plate over the Top Shaft so that the large, flat surface of the Backing Plate rests against the Slipper
Pad.
q
6. Place the Slipper Spacer (107), long side first, onto the Slipper Shaft and against the outer Slipper Backing Plate.
q
7. Place the silver Slipper Spring (108) over the Slipper Shaft, followed by the Slipper Spring Retaining Washer (109) and secure with the
4-40 Locknut (110).
IMPORTANT NOTE:
Before tightening the Locknut, check to see that the Slipper Pads are properly aligned with the notches on both
sides of the Spur Gear. If not, align them before proceeding.
q
8. Tighten the 4-40 locknut all the way down, and then back it off four complete turns (360
o
x 4). This is a good starting point for
adjustment. Final adjustment can be made later.
110
109
108
107
104
105
106
105
104
90
Figure 40
107
109
110
108