![background image](http://html1.mh-extra.com/html/team-losi/bk2/bk2_owners-manual_4004840012.webp)
60
63
62
59
61
47
69
62
27
22
66
67
27
68
7
Step C-1
CVD Dogbone Assembly:
q
1. Apply a thin coat of White Thrust Bearing/Assembly Grease
(87) to the outside of the CVD Coupling (60). Insert the greased Cou-
pling into the large hole in the rear Axle (62) so that the hole in the
Coupling can be seen through the slots in the Axle.
q
2. Place the CVD Dogbone (59) over the rear Axle. Align the holes
in the Dogbone with the hole in the Coupling. Secure all three parts
by inserting a 1/16" x 7/16" (solid) Coupling Pin (61) through the
holes in the Dogbone, the slots in the rear Axle, and the hole in the
Coupling.
IMPORTANT NOTE:
Apply the enclosed thread-lock to the Set
Screw before threading it into the CVD Coupling. If Thread Lock is
not used, the Set Screw could loosen during operation causing your
CVD to possibly fail or be damaged.
q
3. Center the Pin in the Dogbone and secure it by threading a 4-40
Setscrew (63) into the end of the Coupling.
q
4. Build two of these assemblies.
Figure 19
Step C-2
Figure 20
q
1.Thread a silver colored Ball Stud (22) into the inside hole of the
left rear Hub (66), from the front (the side without the recessed area)
and secure it with a 4-40 Mini-Nut (7) as shown in Figure 20.
IMPORTANT NOTE:
Do not overtighten the Ball Studs.
q
2. Place a "Foam Thing" (47) over the Ball Stud.
*NOTE: If the 3/16" x 3/8" Bearings only have one Teflon
seal
(colored, woven-looking) in it, position the seal to the outside of
the Hub.
q
3. Press a 3/16" x 3/8" sealed Bearing (27) into the inside of the left
rear Hub. Slide a rear Axle (62) through the sealed Bearing in the rear
Hub.
q
4. Slide an inner rear Bearing Spacer (67) over the rear Axle, from
the outside, against the inside of the Bearing. Place a second 3/16" x
3/8" Bearing over the rear Axle and press the Bearing into the outside
of the rear Hub.
q
5. Place a rear Axle Spacer (68) over the rear Axle, small side first,
against the outside Bearing.
q
6. Secure the rear Axle and the rear Axle Spacer by inserting a
1/16" x 7/16" Spirol Pin (69) through the small hole in the rear Axle.
The Pin should be centered in the rear Axle.
q
7. Repeat Steps 1-6 for the right rear Hub (65).
Rear Hub Assembly:
BAG C
60
61
63
69
27
67
8
7
22
68