68
15. TRG settings
15-1-2-1. START CONDITION
Current selection
Selection
Use the VALUE knob and up and down (
5
,
b
) buttons to change
the selection.
Press the VALUE knob to change the setting of the selected
parameter.
LEVEL
Sets the level and UP/DOWN conditions for each channel.
EXTERNAL
The options are ON and OFF.
TIMEOUT [sec]
If the conditions set to start recording are not met within a specified
time, recording will be forced to start automatically.
15-1-2-2. STOP CONDITION
LEVEL
Sets the level and UP/DOWN conditions for each channel.
EXTERNAL
The options are ON and OFF.
REC TIME [sec]
Sets the recording time.
15-1-2-3. LEVEL
Set the level trigger conditions for each channel.
LOGIC
This shows the current setting.
Set when there are multiple conditions to determine whether one or
all must be fulfilled.
Press the F3 button to switch between AND and OR.
If LOGIC has been set to AND, monitor a channel on the same unit.
Input a square wave as the trigger signal.
COUNT
This shows the number of times that the condition set for stopping
has occurred.
Press the F4 button to change the setting.
CH
A check mark appears in this column if one or both CONDITION and
LEVEL settings have been set.
CONDITION
This shows the current setting.
Press the VALUE knob to open the settings screen.
LEVEL
This shows the current setting.
Press the VALUE knob to open the settings screen.
OK (F1 button)
Press to confirm the settings and return to the previous screen.
Summary of Contents for WX-7000
Page 1: ...WIDE BAND DATA RECORDER Owner s Manual Z WX 7000 D01190210J ...
Page 84: ...84 19 Exterior drawings WX 7016 340 348 10 8 220 13 8 123 82 40 15 WX 7032 164 82 40 40 15 ...
Page 85: ...85 WX 7064 246 82 40 40 40 40 15 WX 7096 360 370 396 19 Exterior drawings ...
