_ 6 _
1. Press the POWER switch to ON.
2. Set the REV MODE switch to the
required tape travel mode, referring to
the chart "Tape Travel Depending on
Setting of REV MODE Switch" on page 5.
3. Load a pre-recorded cassette in TAPE I
or II.
4. Select the appropriate DOLBY NR sys-
tem.
5. Press the
”
or
∏
button for TAPE I or
II to start playback.
6. Adjust the volume with the amplifier's
volume control.
●
To stop playback, press the
∑
STOP but-
ton.
Playback with TAPE I or TAPE II
1. Load pre-recorded cassettes in TAPE I
and TAPE II.
2. Set the necessary controls and switch-
es but not the
”
or
∏
button, referring
to "Playback with TAPE I or TAPE II" .
3. Set the REV MODE switch to the (
ø
)
position.
4. Press the
”
or
∏
button of the deck to
be played back first.
5. Tapes will be played back continuously,
according to the chart. (See page 5.)
●
To stop continuous play before 5 cycles
have been completed, press the
∑
STOP button of either deck.
Continuous Playback
You can change the tape speed during play-
back, allowing to change the pitch of the
reproduced sound (TAPE I only).
By turning the PITCH CONTROL to the right,
the tape speed becomes faster, resulting in
higher pitch. By turning it to the left, the
tape speed becomes slower, resulting in
lower pitch.
O
At the fully clockwise position, the tape
speed is approx. 10% faster .
O
At the fully counter clockwise position,
the tape speed is approx. 10% slower.
Pitch Control
Note:
In the following steps 1 and 2, to simplify the
description, the explanation is given for
"forward playback" (
∏
direction). A similar
procedure should be used for "reverse
playback".
1. During forward playback, press the
or
Ò
button repeatedly until the
number of tunes to be skipped appears
in the counter display. Use the
Ò
button for searching a tune following the
current tune and
button for a tune
before the current tune. Refer to the
chart "How to Select Any Required Tune
Using CPS".
●
If, by using the
Ò
, the required
CPS number setting is exceeded, use
the
button to count down the
CPS number until the required CPS
number is displayed.
●
When the
Ò
button is pressed, the
next tune is counted as "1" and when
the
button is pressed, the
current tune is counted as "1".
2. The tape is fast-wound to detect blanks
between tunes until the required tune is
reached. Then playback starts from the
beginning of the designated tune.
CPS allows the selection and playback of
any tune up to 20 tunes ahead or before the
one being played. This function operates by
detecting blank spaces of at least 4
seconds between tunes. These blanks can
be created using the REC MUTE function.
Notes on CPS
CPS operates by detecting and counting
blanks of about 4 seconds, the standard
interval between tunes. Therefore, with the
following types of tapes, search functions
may not work correctly.
●
When the intervals between tunes
cannot be detected.
– Intervals of less than 4 seconds.
– High levels of noise in intervals.
– Long low level sections (in classical
music, etc.)
This problem can be corrected using the
REC MUTE function.
CPS (Computomatic Program
Search) Function
