19
Picture-In-Picture (PIP) / Side-by-Side Picture (POP) - Con’t
PIP On/Off
Input Source Selection
PIP Window Position
1. Choose between FIXED or VARIABLE windows position.
2. If set to FIXED, the PIP window can be set in any one of the four
corners of the screen. Use H-LOCATION and V-LOCATION to set
the position of the window.
3. If set to VARIABLE, the PIP window can be variably set to
anywhere on the screen using H-LOCATION and V-LOCATION.
PIP Window SWAP
1. By default, the OSD will always display DISABLE. To swap the
main and sub windows, use the ADJ +/- key to swith to ENABLE.
Once the swap is complete, the OSD will return to display
DISABLE.
POP On/Off
Input Source Selection
Screen Rate (Aspect Ratio Control)
1. When POP (Side-by-side) picture is turned on, you can change
the aspect ratio for the image displayed.
2. Choose FULL to show a full screen image. The displayed image
may appear distorted because the monitor has to manipulate the
image so that it fits within the smaller window.
3. Choose 4:3 to show an image in native 4:3 aspect ratio within the
POP windows. Small black bars are added in order to maintain a
true 4:3 aspect ratio.
4. Choose 16:9 to show an image in wide-screen aspect ratio
within the POP windows. Small black bars are added in order to
maintain a true 16:9 aspect ratio.
PIP Window SWAP
1. By default, the OSD will always display DISABLE. To swap the
main (left) and sub (right) windows, use the ADJ +/- key to swith
to ENABLE. Once the swap is complete, the OSD will return to
display DISABLE.
ADVANCED FUNCTIONS
Notes:
!
PIP mode can only be turned on if the monitor’s input is set to: AV, S-Video, Component 1and 2. If the
monitor’s main input is set to RGB or DVI, the PIP and POP will not function.
!
If the monitor’s input is set to Component 1 or Component 2, the PIP will only turn on if the input signal
source is compatible with 15 kHz signals such as 480i and Y/C
B
/C
R
signals.
!
When changing input source for sub-pictures to Component 1 and Component 2, only 15 kHz compat-
ible signals such as 480i and Y/C
B
/C
R
will result in a video picture display. If another signal other than
15KHz is detected, the sub-picture may display distorted video signals.
!
Once PIP is turned off, the next time you return on PIP mode, the position of the sub-window will start
at default position.
Accessing PIP and POP Modes Modes using OSD
You can also use the OSD menu to access the same PIP and POP mode functions. To access these
modes using OSD:
1.
Press the MENU +/- keys on the remote or the front control panel.
2.
Use the ADJ +/- keys to switch to “PIP/POP” Menu.
3.
Make sure that the “Picture” OSD menu below is displayed.
4.
Use the MENU +/- keys to move up and down to choose the sub-category you wish to change.
5.
Use the ADJ +/- keys to actually change the setting.
Summary of Contents for PLMSDM1060
Page 1: ......
