408-10390
Rev
T
24
of 25
6.9.
Wire depressor accessory
If this accessory was not installed on the applicator at the factory, use Figure 17 to identify the parts you need
in order to add it.
NOTE
To add a wire depressor to an existing applicator, the existing crimper spacer must be at least 0.64 mm [.025 in.] thick.
Figure 17: Wire depressor accessory parts
1
Existing crimper spacer
2
Replacement crimper spacer
3
Wire depressor (select based on wire size range)
4
Wire depressor washer spacer (part number 2119943-1) required
1. Use the following formula to calculate the thickness of the replacement crimper spacer:
�� − 0. mm [.02 in. ] = ��
where:
Se
= Existing crimper spacer thickness
Sr
= Replacement crimper spacer thickness
