408-10390
Rev
T
17
of 25
Servo feed applicator
1. With the terminal strip properly loaded, check the position of the lead terminal over the anvil by
actuating the feeder to move the feed pawl to the extend position. The slug blade must remove the
connecting tab between the lead and second terminals without deforming either terminal.
If the lead terminal is centered on the anvil, the forward limit adjustment is correct. Skip to step 4.
If it is not centered, continue to step 2.
2. Adjust the extend position as described in the feeder instructions in customer manual
3. Repeat steps 1 and 2 as required. When the adjustment is correct, continue with step 4.
4. Watch the feed pawl as the machine is cycled several times.
It should have
enough, but not too much
over-travel on the retract (stroke) to pick up the next
terminal.
At the end of the retract stroke, the feed pawl should be at the back edge of the feed hole to be
used. The back stroke must not be longer than this; otherwise, the feed pawl might not drop into
the feed hole.
5.4.
Adjusting the stock drag
Adjust the stock drag to apply only enough pressure to the terminal strip so that it stops at the end of the feed
finger stroke.
1. Turn the stock drag adjustment nuts (shown in Figure 6) to adjust the drag.
Turn the nuts down to increase the drag.
Turn the nuts up to decrease the drag.
2. Cycle the machine under power to verify that the stock drag is properly adjusted.
