409-35009
Rev E
27 of 44
ADJUSTMENTS
The following adjustments are necessary to maintain the machine in operating condition, and to set up the
machine after replacing parts.
DANGER
To avoid personal injury,
always
disconnect electrical and air supplies before performing adjustments.
6.1.
Shut height
Measuring
The shut height is the distance between the bottom portion of the ram post adapter and the top surface of
the machine base plate. It is measured by installing a Base Plate Adapter P/N 2326544-1 onto the
machine base plate as shown in Figure 21.
NOTE
Shut Height Gage PN 679655-2 (see Table 11) is recommended for measuring shut height (refer to
on use of the gage along with Base Plate Adapter PN 2326544-1).
Follow the procedure for measuring the shut height as described in
Figure 21: Measuring shut height
1
Shut height dimension (see Table 11)
2
Base plate adapter 2326544-1
Table 11: Shut height dimension
Shut height gage
Shut height dimension
(with plate adapter installed)
mm [inch]
Applicator type
679655-2
135.790 ±0.025 [5.346 ± .001]
TE-Type
